Dissembler Rock

Dissembler Rock Camera Set-up

Rock Camera Set-up

1. Battery Installation 

   1. Unpack Battery

   2. Turn Rock upside down, camera chassis closest to you

   3. Velcro on side of battery, facing away from you

   4. Velcro on bottom of battery, facing up

   5. Slide battery under plexiglass

   6. Line up velcro, on bottom of battery and plexiglass, and push into place 

2. Hotspot Installation 

   1. Locate accessory bag with hotspot

   2. Locate the charging port on the hotspot, ensure it is facing outwards so it is accessible when secured into place.

   3. Place the hotspot on the velcro located on the side of the battery. 

   4. Plug in one of the USB wires to the hotspot. 

3. Camera Installation

   1. Remove customized camera from Wyze box.

   2. Locate camera chassis. 

   3. Turn the camera upside down so the reset button and SD slot are facing you.  

   4. Place the camera at an angle to snap it into place on the chassis. 

      1. Recommended to leave camera in once placed, charging and SD card replacement are accessible when camera is installed. 

   5. Take the unused USB wire and plug the camera in. 

4. Wiring Harness

   1. Plug in the battery

Red to Red and Black to Black for battery plug in. 

5. Tuck wires out of the way. 

6. Follow instructions in camera box or found here to set up the camera.