Dissembler Pro

Please be advised, to ensure the safe arrival of your Dissembler Camera product during shipping, some items will need to be reattached or put into place, after their delivery. 

1. Open Enclosure: Unscrew nut and remove nut & washer. Remove packaging. 

2. Note: there is a holder for an Apple AirTag if you would like to add one. 

3. Install Battery: Place battery in at an angle, slightly flex the battery and press the battery into place. Note: there is velcro on the back of the battery to assist in attaching securely. 

4. Install Hotspot: Plug hotspot in. Connect the hotspot with velcro, on the bottom right of the enclosure. 

5. Wire Connections: Plug in female to male black and red wire 

IMPORTANT: Wires must be plugged in red to red and black to black, forcing the wires in the wrong way will cause damage.

6. Camera: A camera will already be installed, be sure to plug it in. You will hear “ready to connect” follow the camera set-up instructions (see link at bottom of this page). 

7. When ready, shut the enclosure. Replace washer and screw on nut. 

Note: you do not need to open the enclosure when deploying.

Dissembler Pro includes two cameras, please follow the instructions at the links below for set-up and the video for switching out the cameras in the case:

Wyze v4 Camera Set-up

Wyze OG Telephoto Set-up

If you purchased the Dissembler Pro Additional Battery Box, set-up video below: