PVC Pro & Standard

Please be advised, to ensure the safe arrival of your Dissembler Camera product during shipping, some items will need to be reattached or put into place, after their delivery. 

Below you can find video and written instructions to assist you in your set-up.

1. Pull out the chassis:

   this is the black frame which will hold the battery, camera and hotspot.

2. Install Battery: Gently flex the chassis and click battery into place.

3. Install camera: Select which of the 2 cameras you would like to use first. Line up camera to open square at top of chassis and slide it in, it will stop when it reaches the back piece that holds it into place.

4. Install Hotspot: set aside charger. Ensure power plug is facing downwards, away from chassis. Connect hotspot with velcro to chassis. Plug wire at bottom of chassis into hotspot.

5. Wire Connections: Plug in female to male black and red wire coming from below and above the battery.

   IMPORTANT: Wires must be plugged in red to red and black to black, forcing the wires in the wrong way will cause damage.

6. Wire Management: Locate the grooves behind the camera and place the excess wire in the groove.

7. Wire Connections: Plug white camera wire into longer solid black wire.

8. Wire Management:  Locate the grooves behind the camera and place the excess camera wire in the groove.

9. Before placing the chassis in the enclosure, remove the protective film on the camera and set-up the Camera either by following the directions here or using the quick start guide included in the camera box.

10. Once camera is set-up, slide the chassis into the enclosure, ensuring you line up the camera hole with the camera.

Dissemble PVC Pro & Standard include two cameras, please follow the instructions at the link below for set-up of both:

Wyze OG: Wide & Telephoto Set-up